The construction of EOGB burners is based on criteria aimed to create heating units which are extremely reliable and which offer easy access to every single component, an important factor when it comes to repairing, cleaning, checking or servicing the equipment.

• Excellent Pressure Characteristics
• The compact size of the burners in proportion to their capacity.
• Very low electrical energy consumption.
These features complete the technical and functional
checklist of a product with a high technical content.

Monoblock burner casing in cast aluminum.
Fan having a specially designed structure with strong pressurization, to ensure safe operation even when the burner is fitted on semi-pressurized boilers.

Combustion head constructed to produce the best burner combustion rates at every point in the operation range.
Electronic equipment controlling the entire operating cycle and safety functions.

Wide range of models and capacities.
Easy to install and service.
The burners are supplied ready for installation.

EOGB burners are constructed in single-stage, two-stage and fully modulating modes.

• Single-stage: the burner is provided with only the on-off functions.
  
• Two-stage: the burner operates on high-low function, a low flame function and a maximum thermal power function. From this last position, the burner can automatically (by control of the specific thermostat or pressure switch) switch back to low flame operation.
  
• Modulating: modulating burners are used whenever the thermal power has to be varied continuously in order to adapt itself to the specific needs of the system requirements. This type of operation can be obtained by equipping the models with a progressive two-stage system with automatic thermal power regulator which, with the use of a sensor (either temperature or pressure) controls the regulation servo motor, either by increasing or decreasing the thermal power supplied. The regulator is a PID type (proportional, integral, differential). Parameters can be adjusted by affecting the data settings on the regulator. Naturally, the thermal power level can only be varied within the "minimum" and "maximum" limits applying to the burner.